Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Why Georgetown Homeowners Choose Lennox Air Duct Cleaning
We provide independent Lennox air duct cleaning and service in Georgetown, TX. If you own a Lennox system, we know the cabinet layouts, coil configurations and variable-speed airflow logic well enough to diagnose what’s actually happening inside your ductwork and fix it with equipment suited to the job. We’re not affiliated with, authorized by or sponsored by Lennox. We’re an independent specialist, and that independence is why we can tell you the truth about your system.

Lennox equipment earns its reputation. It also has habits worth knowing, especially in Central Texas. That’s what this page is about. We cover Georgetown homes from the Courthouse Square core to Sun City and the Wolf Ranch corridor, and we bring contractor-grade tools to every job: Rotobrush rotary-brush systems, Nikro collection equipment, and Abatement Technologies negative-air filtration that contains debris instead of blowing it back into your living space.
We also repair ductwork, which most cleaning-only operators won’t touch. If a Lennox air handler is straining against leaking flex duct in a 140°F+ attic, cleaning alone won’t fix the problem. We fix the system, not just the surface of it.
Key Takeaways
- Independent Lennox service, not a dealer or factory-authorized shop. We work on the brand daily and speak plainly about it.
- We handle Lennox variable-speed air handlers, cased coils and condensing furnaces, and the ducting they’re wired into.
- Georgetown’s new construction leaves drywall dust and insulation fibers in return plenums; that’s a cleaning problem, not a filter problem.
- Three services under one provider: Air Duct Cleaning, Dryer Vent Cleaning, and Air Duct Repair.
- Call (844) 560-6431 for a free estimate.
Why Trust Duct Cleaning Georgetown for Your Lennox Air Duct Cleaning?
Our technicians have up to experience, and much of that time has been spent inside systems with names like Signature Collection, Merit Series, Elite Series and the L Series cast on the cabinet. We know how a CBX40UH or CBX32MV variable-speed air handler is put together, where its filter rack sits, and why an ECM blower ramp-up can mask a duct problem for months. We know that a CX34 or CH33 cased coil has tighter clearances than some competing cabinets, which changes how you clean it without bending fins.
On parts, we take a practical line. Where fit matters (filters, gaskets, coil components), we use Lennox-compatible parts that seat correctly. For flex duct, mastic and insulation, quality matters more than the label, so we use materials that hold in a Georgetown attic. We don’t claim to be a dealer, and we don’t stock genuine Lennox parts.
Warranty-safe practice is part of the job, not an add-on. We document what we find and what we do, we don’t disturb equipment in ways that create complaint grounds, and we leave your system functioning as the manufacturer intended. If something looks like a warranty matter, we tell you. Call (844) 560-6431 for a free estimate.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Common Lennox Air Duct Cleaning Problems We Fix in Georgetown
The symptoms Georgetown owners call about follow the hardware. Here are the patterns we see most often in Lennox systems.
- Variable-speed air handlers pulling dust past marginal filters. Units like the CBX40UH and CBX32MV run near-constant low airflow, which quietly loads the blower wheel with fine dust and lint. Static pressure climbs, the ECM motor ramps up, and the system compensates instead of complaining. The symptom shows up as high bills or uneven cooling, not as a fault code.
- Condensing furnace moisture in Georgetown humidity swings. Signature Collection high-efficiency furnaces with secondary heat exchangers condense heavily when Central Texas humidity moves fast. A leaking condensate trap or gasket wets the return duct and gives microbial growth a place to start. That’s the musty smell, not a dirty filter.
- Cased evaporator coils with dust on the downstream face. Lennox cased coils like the CX34 and CH33 have tight cabinet clearances, and dust collects where you can’t see it from the service panel. Airflow chokes, the coil freezes in summer, and cooling performance drops even though the system is running.
- Flex duct collapsing or tearing at the collar. Insulated flexible duct runs on attic-mounted Lennox air handlers take extreme attic heat for months. When they tear at the collar, conditioned air leaks out and attic insulation fibers get pulled into the supply side. That’s a job for air duct repair, not another vacuum pass.
- Return plenums loaded with construction debris. In newer Georgetown subdivisions, builder-grade flex duct and attic installs pass inspection but still leak at every joint. Drywall dust and blown insulation collect in the return, and the system distributes it every time it runs.
These symptoms look like hardware failures. Most of the time they’re airflow and containment problems, and cleaning plus repair solves them.
Lennox Parts & Our Repair-vs-Replace Approach
We use Lennox-compatible filters, gaskets and coil parts where fit matters, and quality aftermarket flex duct, mastic and insulation elsewhere. We don’t stock or order genuine Lennox parts, and we’re not a dealer. What we do is fit the right part to the right cabinet so it seals and lasts.
On older Lennox equipment, replacement is our last recommendation, not our first. Duct sealing, blower cleaning and coil treatment come first. Those three fixes solve most of what looks like a failing system, and they cost less than a swap. We recommend replacement only when the heat exchanger or coil is genuinely compromised. A cracked heat exchanger is a safety concern, and we’ll say so plainly. A dirty coil is not.
If you’re weighing that decision and want a straight answer about your specific Lennox system, call (844) 560-6431 for a free estimate.
Our Lennox Service Process – Step by Step
- 1
Diagnosis. We measure static pressure, inspect the filter rack and blower, and check the cased coil and return ducting. On a variable-speed air handler, we look at airflow behavior against how the system is configured, not just the thermostat reading.
- 2
Cleaning and repair. Using Rotobrush rotary tools and Nikro collection equipment, we clean the system source to register. Abatement Technologies negative-air filtration holds containment while we work, so debris stays where it belongs. Duct leaks get sealed with mastic and, where needed, replacement flex duct.
- 3
Coil and blower service. We clean the evaporator coil face and the blower wheel by hand where the equipment allows. Cased coils and ECM blowers don’t tolerate rough handling, and on Lennox cabinets the clearances are tight.
- 4
Test and document. We verify airflow, check for leaks at the collars, and photograph before-and-after conditions so you can see exactly what changed. You get the record, which matters for property managers and landlords.
- 5
Warranty review. We note anything that looks like a manufacturer issue so you can raise it with Lennox through the proper channel. We don’t handle warranty claims, but we’ll flag what needs flagging.
See the difference
Before
After
Before
After
Before
AfterLennox Products We Service & Install in Georgetown
We service and install across the Lennox range: gas furnaces, air conditioners, cased evaporator coils, air handlers, and the systems that tie them together. That includes high-efficiency furnaces with secondary heat exchangers, variable-speed and communicating air handlers, and the ducting those units depend on. We also work on the components around them: filters, filter racks, thermostat wiring, and the flex and hard duct runs that connect everything.
If you’re not sure what you have, we’ll tell you after we see it. Call (844) 560-6431 for a free estimate.
We Also Service These Brands
Lennox is a specialty of ours, not our only work. We service and clean duct systems on Trane and Carrier equipment too, and the same process applies: contractor-grade tools, real containment, and repair when repair is what’s needed. If your home has mixed equipment or a property has units from more than one manufacturer, you deal with one provider instead of three. Three services, multiple brands, one accountable crew.
FAQs – Lennox Air Duct Cleaning Service in Georgetown
No. We are an independent service provider, not a Lennox dealer, authorized repair center or sponsored partner. We work on Lennox systems daily and know the equipment well, but we have no manufacturer authorization or warranty endorsement. That independence means we give you the straight answer about what your system needs rather than steering you toward a replacement.
Yes, where fit matters. We use Lennox-compatible filters, gaskets and coil parts so components seat and seal properly, and quality aftermarket flex duct, mastic and insulation elsewhere. We don’t claim to stock genuine Lennox parts, and we’re not a dealer. What matters is that the part fits the cabinet and holds up in a Georgetown attic.
Most full system cleanings take a few hours, depending on the number of returns and the condition of the ducting. Coil and blower cleaning on a cased Lennox unit adds time because the clearances are tight and the work is done by hand. Duct repair jobs vary with how much flex duct needs replacing. We’ll give you a realistic time estimate before we start.
Gas furnaces, air conditioners, cased evaporator coils, air handlers and the ducting that connects them, including variable-speed and communicating air handlers. We service and install, but we don’t sell Lennox equipment as a dealer. If you’re unsure what you have, call (844) 560-6431 for a free estimate.
Proper cleaning and repair generally won’t void a manufacturer warranty, but we don’t issue warranty rulings and we can’t speak for Lennox. We work in a way that respects the equipment, document what we find, and flag anything that looks like a manufacturer defect so you can raise it through the right channel. When in doubt, ask Lennox directly.
Most whole-system cleanings land in a range that depends on the number of returns, the size of the system and the condition of the ducting, so we quote per job after we see the system rather than advertising a teaser price. What we won’t do is quote per vent or lowball you and raise the invoice once we’re on site. You get one flat price per system agreed before work starts, and before-and-after photos of your own ducts so you can verify the work. Call (844) 560-6431 for an exact quote. Estimates are free.
It often is. Variable-speed ECM blowers are designed to run at lower speeds for longer, but constant low-speed operation can mean the blower wheel is coated with dust and the motor is compensating for rising static pressure. That’s usually a duct and blower cleaning problem, not a failing motor. Call (844) 560-6431 for a free estimate.
Yes. The downstream face of a cased coil collects dust that duct cleaning alone won’t remove, and tight cabinet clearances mean it needs careful hand cleaning. When that face mats over, airflow chokes and the coil can freeze in summer. Coil cleaning is part of a full system cleaning on Lennox equipment, not an optional add-on. Call (844) 560-6431 for a free estimate.
On a high-efficiency furnace with a secondary heat exchanger, heavy condensation during Central Texas humidity swings can wet the return duct if a condensate trap or gasket is leaking. That moisture breeds microbial growth, and you smell it at the return. It’s a containment and repair problem and a good reason to call: (844) 560-6431 for a free estimate.
Yes. Flex duct on attic-mounted Lennox air handlers commonly tears or collapses at the collar, and Georgetown attics push past 140°F for months, which degrades insulation and seals. We clean the run, replace damaged sections with quality flex duct, and seal the collars with mastic. That’s air duct repair, a standalone service we offer. Call (844) 560-6431 for a free estimate.
Book Your Lennox Service in Georgetown, TX
If your Lennox system is running harder, smelling musty, or cooling unevenly, the answer is probably in the ductwork. We bring Rotobrush, Nikro and Abatement Technologies equipment into your home, contain the debris, and leave you with before-and-after photos of the work. Three services, one accountable provider. Call (844) 560-6431. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free.
Written by the team at Duct Cleaning Georgetown.